C1240 K9w7 Tar 124 25d Ja2 Tar 15
C1240 K9w7 Tar 124 25d Ja2 Tar 15 ->->->-> https://urllie.com/2tyQSW
How to Upgrade Cisco 1240 Series Access Point to Autonomous IOS
Cisco 1240 series access points are wireless devices that can operate in two modes: lightweight and autonomous. Lightweight access points are managed by a wireless LAN controller (WLC), while autonomous access points run their own operating system (IOS) and can function independently. In some cases, you may want to upgrade your Cisco 1240 series access point from lightweight to autonomous mode, for example, if you want to use it for site survey or standalone operation.
In this article, we will show you how to upgrade your Cisco 1240 series access point to autonomous IOS using the C1240 k9w7 tar 124 25d ja2 tar 15 file. This file is an autonomous IOS image that supports the 1240 series access point and has the version number 12.4(25d)JA2[^2^]. You can download this file from the Cisco website or use the one that is bundled in the WLC software image (.aes) [^2^].
Before you begin, make sure you have the following:
A Cisco 1240 series access point that is currently running lightweight IOS (k9w8 or rcvk9w8) [^2^]
A TFTP server that is reachable from the access point
A console cable and a terminal emulator software to connect to the access point
The C1240 k9w7 tar 124 25d ja2 tar 15 file that is stored on the TFTP server
Follow these steps to upgrade your Cisco 1240 series access point to autonomous IOS:
Connect your console cable to the access point and open a terminal emulator software on your computer. Set the baud rate to 9600, data bits to 8, parity to none, stop bits to 1, and flow control to none.
Power on the access point and press Esc when you see this message: ap: booting the image. This will interrupt the boot process and enter the ROMMON mode.
In ROMMON mode, set the IP address, subnet mask, default gateway, and TFTP server IP address of the access point using these commands:
ap: set IP_ADDR
ap: set NETMASK
ap: set DEFAULT_ROUTER
ap: set TFTP_SERVER
Verify that the settings are correct using this command:
ap: printenv
Download the C1240 k9w7 tar 124 25d ja2 tar 15 file from the TFTP server to the access point flash memory using this command:
ap: tar -xtract tftp:///C1240 k9w7 tar 124 25d ja2 tar 15 flash:
Wait for the download to complete. You should see a message like this: Bytes transferred = xxxxxxxx (xxxxxxxx hex).
Rename the flash:config.txt file to flash:private-config.txt using this command:
ap: rename flash:config.txt flash:private-config.txt
Set the boot image to the autonomous IOS image using this command:
ap: set BOOT flash:/c1240-k9w7-mx.124-25d.JA2/c1240-k9w7-mx.124-25d.JA2
Save the settings and reboot the access point using these commands:
ap: saveenv
ap: reset
The access point will reboot and load the autonomous IOS image. You should see a message like this: *Mar 1 00:00:00.000: %SYS-5-RESTART: System restarted -- Cisco IOS Software, 061ffe29dd